6SN1145-1BA02-0CA2 -New

Siemens-Power Supply

D-4

No enciende led. Refund PO:28129 ( replacement return. Customer Notes: I have installed the Simodrive in the gantry drill that I have here. The drive powers up just fine and I am able to run my Z axis but I am only able to run the spindle up to 385 RPM and turn off the spindle without the drive going into a red light fault. If I run the spindle any faster and then turn the spindle off the drive gives me a red fault light, lower right on the drive display. Am I seeing a regen fault on this n